☆How to fix block inserted in table cell not centering correctly in ZWCAD

Issue:

he block position in the cell is visually offset, even though the Alignment in the Properties panel is set to Middle Center. How to resolve this?

Causes:

This is generally caused by the bounding box of certain objects inside the block being too large.

1. Enter BEDIT (Edit Block Definition) and press Enter. Select the target block from the list and click OK. You may notice the block is offset in the preview.
   
   
   
2. In the Block Editor, press Ctrl+A to select all objects. If you see grips (stretch points) appearing far away from the main geometry, it confirms the range is too large.
   
3. In this example, the grips belong to an MText (Multiline Text) boundary frame that is too wide.
   

Solution:

1. Enter X (Explode) and press Enter to explode the MText into Single Line Text. The out-of-range grips will disappear.
   
2. Enter BCLOSE and press Enter, then select Save the changes.
   
3. Select the target cell in the table. In the Properties panel, re-select the Alignment as Middle Center. The block should now display correctly.