★How to create linear array flexiblock in ZWCAD

Issue:

If we want to achieve an array effect of a block by stretching it, how to make this kind of stretchable flexible block?

The stretch example is shown below:

Solution:

1. Take the sofa as an example. Click the Block command (BLOCK command), after defining the base point and name of the block, double-click to enter the block editor to edit the block.
   
2. In the Block Editor, click Linear to add a linear parameter to the graphic.
   
3. Then click Stretch to add a stretching action to the table in the block, and determine the stretching direction to give the block the ability to stretch.
   
4. Finally, add another array action on the linear parameter. After clicking the Array command, select the sofa that need to be arrayed in the drawing, set the array spacing and click OK. The array action is now added. Finally, close the block editor.
   
5. Click the block's grip point to stretch the dynamic block.