★Why the part list can not get the information of standard parts in ZWCAD MFG

Issue:

After the standard parts generated from the Part Library are labeled with balloons, why the generated parts list can not read the standard parts information?

Causes:

When annotating the balloon, if the arrow of the balloon is not on the element of the standard part, it will result in the inability to read the information of the standard part.

Solution:

When marking the standard parts called out from the Part Library, as shown in the figure below, define the leader point on the elements of standard part to make the information be read.

Note: If the balloon has been marked and the generated part list has no content, it need to relabel the standard parts with balloons.