★Why does ZWCAD draw a rectangle with line width

Issue:

Why does ZWCAD draw a rectangle with a thick line as below?

Causes:

• Draw in a layer that has set the line weight.
• Rectangle is created as a polyline, if the polyline has been set specific line width, it will also apply to the rectangle. Check the command line if there is any specific line width assigned.
  

Solution:

Solution 1:

1. Adjust the line weight of the corresponding layer.

Solution 2:

1. Input shortcut command RECTANGLE, then input W for branch command Width
2. Input value 0 to change the width to default.