Issue:

How do I generate the G70 finish cycle command in the turning module?

Solution:

To output a G70 command following a roughing cycle, set the Path Settings within the rough turning operation as follows:

  1. Set Output Type to Cycle, and enable the Output Finish Cycle Command option. This will generate the G71 command for the rough turning cycle.
  2. The post-processor will automatically append the corresponding G70 finish cycle command after the G71 block, using the same contour defined for roughing.


CN Solution
JP Solution


★How to generate the G70 finish cycle command in the turning module：https://confluence.zwcad.com/pages/viewpage.action?pageId=337406854

  • No labels